More performance and comfort for your BMW RnineT / Racer / Pure with the Zwart-T shock absorber Type Stage3 . Wether you set off to ride through many curves or to have a nice tour with your friends, the great adjusting range allows you to get a better setting of balance and damping as you could with the standard components. The Stage3 emulsion shock absorber can be adjusted via a hand wheel that adjusts the hydraulic spring preload. to be adapted to the load of the big travel luggage. The finely adjusted damping allows you to fine-tune the bike for any road condition and intended use, regardless of motorways/fast roads, country roads, country lanes or a speedy, ambitious driving style. The new dimension of chassis for your BMW RnineT / Racer / Pure.

Facts at a glance:

– This shock absorber is configuRood and adjusted ready for use based on our experience with the BMW RnineT.

– The parameters are: vehicle weight / shock absorber pivot point / design constraints / test rides.

– As with all suspension solutions, the rear and front of the motorbike should be modified together.

– If only one component is changed, optimal handling will not be achieved.

Properties of the Zwart-T Stage3 shock absorber:

– The shock absorber housing is made of Aluminium. This results in lowest possible weight.

– Fitted with special low-friction seals with integrated Teflon back-up ring for low wear and long durability of the shock absorber.

– Emulsion construction and finer responses of the shock absorber.

– Large 16 mm piston rod made of chromium-molybdenum Staal for maximum stability and durability

– 46 mm damping piston with special Touratech setup.

– The suspension spacer is fitted with sturdy RVS Staal bushings for the fastening screws. This gives the fastening screw a firm, backlash-free fit, even at highest loads.

– All assemblies and components are designed for intensive touring use.

– High End hydraulic preload via an easily accessible, well positioned hand wheel.

– Fully service-enabled. This allows permanent maximum ride dynamics.

Scope of delivery:

– Ready-to-mount shock absorber.

– General Operating License

– Mounting instructions / user manual

“Optional” also available with Zwart exchange spring

The basic setup fitted here is designed for riders up to 100 kg aditional luggage. Modifications are possible for a heavier rider (more than 100 kg) and/or if the bike is usually ridden with a passenger / with luggage. In this case, we individually modify the shock absorber to meet your needs by fitting a spring with a higher spring rate. Please use our suspension check and send us the completed form.

f you have any further questions, we will be happy to advise you. Contact us.